We have scoured the internet to bring you quality guides, videos and manuals on this subject so you don’t have to. We hope you find this page useful. Use this guide at your own risk. All guns must be dismantled with all trigger assemblies and firing pins removed prior to shipment to us.

For Shotguns

Step 1
First and foremost ensure your gun is unloaded before attempting to dismantle. Break down the action on a single shot. Take the forearm off first, and then remove the barrel from the frame. Remove trigger group and firing pin.

Step 2
For the pump action gun, slide the pump action all the way back, then unscrew the top of the tubular chamber so you can twist off the barrel from the gun.

Step 3
Pull the semi-automatic action all the way back, then unscrew the cap at the end of the forearm. This allows you to slide the forearm off, freeing the barrel to slide off the frame. The cleaning procedure for the semi-automatic is the same except for the gas chamber. This chamber must be removed. Because there are variations in the removal instructions for different models, remove the gas chamber according to the owners manual.

For Handguns

Step 1
Unload and Click the safety button in on the gun to make sure that it does not go off accidentally while you are dismantling it. For most guns the safety is on the right side of the handle near the top left corner of the gun’s trigger.

Step 2
Remove the gun’s magazine, which holds the bullets, by pressing the release button on the side of the gun’s handle. While holding down the release button, slide the magazine free and set it aside.

Step 3
Pull back on the gun’s slide, which is on top of the gun’s barrel. When you pull back the slide you will see if there is a bullet still in the chamber. If there is still a bullet in the chamber, pulling back the slide quickly should make the bullet pop out. However, if the bullet does not pop out on its own then you will need to carefully remove it while holding the slide open.

Step 4
Remove the gun’s slide piece by locating the two release buttons on the right and left of the slide directly above the gun’s trigger. Pull back slightly on the gun’s slide. Push both release buttons down and push the gun’s slide forward. This will make the slide separate from the rest of the gun.

Step 5
Flip the slide over to expose the string and barrel of the gun. Remove these pieces by first pushing the string forward so that it can be separated from the barrel. After the string is removed the barrel can be lifted out freely.

()